LagondaNet

The ECU with the 35 way connector is located behind the fascia on the passenger side.

Remove the lower leather trim, the wood and then the top panel and you will see it.

But - I reckon that the ...

Hi,

What Vincent means - quite correctly - is that the steel 'D' post area that is normally covered by an aluminium over trim can and does corrode really badly.

When this happens, the shape of ...

Hi,

The larger diameter outlets from the A/C unit on each side go to each of the fascia side vents near the doors. - These are cold air delivery pipes from the A/C evaporator unit.

The smaller p ...

Hi,

I'm still away but sad enough at times to check e-mails!

The CRT boards require a constant 12V input.

"12V" ignition will actually range from 8.5 to maybe 16 volts depending on ...

Hi,

If you have the computer with three individual video boards, this earlier version should have a heat sink on one of the outside faces and the power supply to it is simply a 12V supply via the n ...

Hi again,

The CRT tubes are in fact very reliable and durable, we've only seen one failed unit so far and they are available from various sources.

As regards colour output, the AUDIT computer ha ...

Hi,

The white is 12V ignition supply.

The red is the 5V supply to the computer - this should go to the red wire of a twisted pair of red and black wires.

The orange is 12V to the CRT driver b ...

Hi,

The XJS pump will only fit the fuel injected cars, it needs to be a pump from the carburettor 3.4L or 4.2L S11 XJ models with submersed pumps.

David

Hi,

I assume that VIN 13441 is a carburettor car, if an EFI unit, the pump is under the car just in front of the right side of the rear axle. - But the problem could well be an issue with relays (u ...

Possibly to do with the automatic ignition advance/retard system.

Too complex to go into here but at idle, the engine runs in quite a retarded mode and this is dictated by the closing of a micro s ...

Hi,

I'll take them please.

Can you mail me at david@davidmarksgarages.co.uk and we can arrange how to pay etc.

Thanks for the offer, it would be a shame for them just to go.

David

For the passenger side, as Vincent says, start with the lowest section (leather) and remove the two screws from under the lower lip and pull down and away.

The next wood section is retained by the ...

Hi,

Yes, you will need to remove the wires from the terminal blocks and re assemble afterwards.

Take careful notes and pictures and disconnect the battery!

David

Apparently bid to £38,600 but still says reserve not met and bidding has ended.

So, not sold, I assume...

David

Hi,

You don't need to remove the front glasses;

If the screws are fitted, they can be accessed by removing the grommets above the glasses with the bonnet open and then a long screw driver can un ...