LagondaNet

I can answer my own question now, I pulled the E-Type off the hoist and bit the bullet re Lagonda.
It can be done and not too difficult.

First up drain the transmission.

Use a transmission jac ...

Not to worry all of the mounts are fine its the bush in the extension housing that is causing the vibrations and odd clunk! Sorting that now.

OK so the bushing and seal in the auto trans extension housing are the cause of the vibration and fluid leak in my car, looks to be an easy job to replace but first off I need to remove the prop shaft ...

Hi all,
is the transmission mount the same as the two engine mounts? (Jaguar V12 items) I cant get my car on the hoist at the moment but will order the parts in advance.
Also the 3 diff mounts, any ...

This might sound silly but its not just a sticky door seal holding the door shut? I had to replace the small back door window in mine and the slightest misalignment of the window frame made the door i ...

My car was burnt from rear window back and the rest of the paint wash shot, every panel had a dent of some sort. I was tempted to change the colour as I like white or dark green and there were some v ...

Just a forgotten update for anyone following this thread.
I replaced a couple cracked vacuum lines between the two airboxes but this didn't seem to do anything ( they were cracked so needed replacing ...

Great reply thanks David!

I'm aware of the ECU and location but assumed wrongly there was another pin.

Ill check all the vacuum pipes and go from there, none have been changed for probably 15 ye ...

My car is the second Fuel Injected car (13465) and has decided to blow a lot of smoke and soot up the plugs on start up, ran for about 1 minute and I had to turn it off due to the amount of smoke! L ...

yeah mines injected so I do have the sensors, the cats are still on at the moment so I'll disconnect the sensors and go for a drive and see what happens.

Hi Vincent,
what did you do with the lambda sensor leads, just tie them off somewhere?
I've removed the air pumps, mainly because one was seized and they serve no purpose now anyway,
cheers
Steve

After 7 years of dicking about I have finally driven 13465!
Exhaust is noisy middle muffler rubs slightly on the tailshaft which is an easy fix but the cats rattle so thinking of gutting them or remo ...

Now the screens are in I should not that there is no "rubber strip" (confirmed with the guys at Aston Martin) and per Harry's note, just glue it in, so we did.
Just make sure you have suffi ...

My windscreen guy was wrong, the U shaped rubber channel fits between the outer edge of the glass and the body and holds the trim in! So now we know that the glass will go in early next week.

Thanks Harry,
Just had the windscreen fitter out for a look and it appears there's a rubber strip that fits around the body first to hold the Windscreens at a given height before its glued in. I do h ...